Join the waitlist for full-failure support

Does SKY-TECH SKY MAKER A1 have AI?

  • Home
  • Does SKY-TECH SKY MAKER A1 have AI?

How to fix, prevent, or detect failures and defects on the SKY-TECH SKY MAKER A1 with PrintWatch.

3D Printers will result in failed prints due to issues like: spaghetti, stringing, layer shift, bed adhesion, clogging, and more. These failures occur due to a variety of factors that are difficult to control. It is important to detect these issues as soon as they happen in order to save material, time, and energy. 
These issues can be detected by using an AI monitoring system called PrintWatch that works with almost any printer. It can be used with or without the Cloud and can be run directly on the printer’s hardware.

How to use PrintWatch AI for the SKY-TECH SKY MAKER A1

Does the SKY-TECH SKY MAKER A1 have AI?

If your printer is compatible with OctoPrint, Duet, RepRapFirmware, Klipper, or Mainsail then you are able to easily use PrintWatch AI on your printer. If your printer doesn’t use one of the listed frameworks, you can still use the AI with a custom integration.

OctoPrint Plugin

OctoPrint users can install our plugin via the Plugin Manager and begin printing with just a few clicks.

RepRapFirmware & Duet3D Plugin

RepRapFirmware and Duet3D users can install our plugin and begin printing with just a few clicks.

Klipper Plugin

Klipper users can install our plugin via the Mainsail and Moonraker integration and begin printing with just a few clicks.

API

Customize PrintWatch to work for your project. Scale up to thousands of printers and create custom features using our API. If you are an OEM, contact us to begin collaborating.

How to setup SKY-TECH SKY MAKER A1 on OctoPrint?

The SKY-TECH SKY MAKER A1 can be setup on OctoPrint by flashing the official OctoPi image onto a Raspberry Pi or similar device and following the official installation instructions found here: https://octoprint.org/download/. This is assuming your printer is compatible with OctoPrint, which you can check here.

How to setup SKY-TECH SKY MAKER A1 on Klipper/Mainsail?

The SKY-TECH SKY MAKER A1 can be setup on Klipper by following the official installation instructions found here. This is assuming your printer’s mainboard is compatible with Klipper, which you can check here.

PrintWatch: 3D Printing,
without the headache

  • No more wasted time and material
  • Get notified when something goes wrong
  • Begin printing with AI in less than 10 minutes