Description
Tabletop stand for the Switch 2 with the Joy-Con 2 still attached. It holds the console at about 65 degrees. When you want it out of the way, pull the two red braces and the frame folds down flat onto the base for storage. Take the console off first, obviously.
The middle is left open so nothing presses on the bottom port. Charge from the top USB-C port while it's on the stand.
Hardware:
- 2x M4x40 socket head screws for the hinge
- 2x M4x20 screws for the braces
- 4x M4 nuts and 8x M4 washers
- 2 spacers, 4.3 mm ID, 8 mm OD, 7 mm long
- 4 stick-on feet around 10x10x6 mm and a few thin silicone strips for the shelves
Tighten the hinge screws just enough to take out the wobble. The braces carry the weight, not the hinge, so don't leave them out.
PETG, 4 walls, 20 to 25% infill. Only the hinged frame needs supports, under the raised back and the front lip. Keep support out of the pivot holes. There's a small test strip with 4.2, 4.4 and 4.6 mm holes for checking your M4 fit before you print the big parts.
Fit comes from Nintendo's published dimensions, not a physical test, so treat it as a first version. Lift the console up along the angle of the frame before pulling it forward or it catches on the front lip. Keep a hand on the base if you're using the touchscreen. Cases won't fit.
This model is licensed under
Creative Commons Public Domain
This licence allows derivative works. Open it in a tool to build on it — credit is filled in for you when you publish.
Discussed in
Similar models
Galaxy Z Fold6 • foldable • Samsung
Span Stand for Galaxy Z Fold6, Fully Open | Hinge-Free Support | Desk Cradle
studybridge • bookstand • deskorganizer
Comments