Description
Small box for the Joy-Con 2 wrist straps and a charging cable, so they stop sinking to the bottom of a backpack.
Two trays sit on ledges inside the case, each with a channel about 127 x 18 mm. The straps are 116 x 16.4 x 7 mm without the cord, so there's a bit of room around them. Under the trays there's open space for a coiled cable. The lid just lifts off and doesn't latch, so put a velcro strap around it before it goes in a bag. 15 mm wide and roughly 450 mm long does it.
Everything prints flat with no supports. PLA is fine if it stays inside, PETG if it rides around in a car. Two little coupons in the files let you check the tray clearance on your printer first. Straps and cables only, it's not meant to hold the controllers. Not waterproof either.
This model is licensed under
Creative Commons Public Domain
This licence allows derivative works. Open it in a tool to build on it — credit is filled in for you when you publish.
Discussed in
Similar models
switch 2 • nintendo switch 2 • console stand
Switch 2 Folding Stand With Removable Braces
MagSafe • travel • cable organizer
Comments