Description
Phone stand, earbuds tray and a spot for the charger, all one piece. The thing I cared about most: the phone sits on two pillars 42 mm up, so its weight is never on the USB-C plug. The plug and the bend of the cable hang free underneath.
The charger sits on ribs in an open bay with a 3 mm air gap around it and vents in the sides. Grooves take the cables to the phone and the earbuds, and the AC cord goes out a notch at the back. Don't cover the bay.
Sizes I designed around (all assumptions, so measure your stuff):
- phones 45 to 80 mm wide, up to 12 mm thick with the case (the thick_case file goes to 16 mm)
- charger up to 64 x 64 x 30 mm
- earbuds case up to 60 x 44 mm
- cables up to 4.8 mm
160 x 140 x 128 mm, about 160 g. Print it base down without supports. Shallow recesses underneath take four 10 mm rubber feet if you want them.
Plug the phone in first, then set it on the pillars. It's not a wireless charger. There's been no heat testing and no test print, so watch the charger the first few times you use it. If you want somewhere to put the charger when it's unplugged, there's the charger bin.
This model is licensed under
Creative Commons Public Domain
This licence allows derivative works. Open it in a tool to build on it — credit is filled in for you when you publish.
Discussed in
Similar models
phone stand • desk organizer • desk tray
Case-Friendly Phone Stand & Desk Tray — Fits Phones in Cases up to 84 mm Wide, No Supports
phone stand • iPhone stand • iPhone 16e
Cradle iPhone Stand with USB-C Pass-Through | iPhone 15-18, 16e, 17e & Air | Thick Cases OK
MagSafe • travel • cable organizer
Comments