Description
Pair of C brackets that screw to the underside of a desk, so the controller stops taking up desk space between sessions. It slides in from the front and sits on the wide lower shelves.
Start with them about 96 mm apart center to center and adjust after holding your controller up to them. Uses four #8 x 5/8" wood screws with washers, into solid wood or plywood. Skip hollow core desks, thin veneer and cheap particleboard. The mounting plate is 8 mm thick and the screws go about 8 mm past it, so make sure your desktop is thicker than that.
To get the controller out, lift it a little and pull toward you.
Both brackets print on their sides the way they're oriented in the files, PETG, no supports. Made for a bare DualSense, so no Edge, no cases and no Xbox pads. There's no load rating and the fit is based on Sony's published size, so hang something you don't care about from it before the controller goes in.
This model is licensed under
Creative Commons Public Domain
This licence allows derivative works. Open it in a tool to build on it — credit is filled in for you when you publish.
Discussed in
Similar models
under desk drawer • gridfinity • hidden storage
Comments