Description
Screw-on drawer for under a desk. The floor is a 3x3 Gridfinity baseplate, so bins can move between the desk and the drawer.
The housing prints upside down, which makes its 45 degree rails self supporting. The runners on the drawer ride on those rails and center themselves. It pulls out 95 mm and stops with 33.5 mm still on the rails.
Hardware
- 4x #8 (4 mm) countersunk wood screws: 16 mm long for desks 18 mm or thicker, 12 mm for 14 to 17 mm
- 2x M3 x 6 pan head screws, these are the stops
Install
- Print the two rail test pieces and check that the runner slides.
- Hold the empty housing under the desk with the front flush to the edge and mark the four holes.
- Screw it up through the top plate from inside.
- Slide the drawer in all the way.
- From underneath, drive the two M3 screws into the pilot holes near the front of each rail until the heads seat. Don't crank on them.
To take the drawer out, remove those two screws.
Inside it's 126.5 x 126.5 mm, and bins can be up to 34 mm tall measured from the bottom of the feet. The tweezer tray, SD card tray and bit holder fit. The charger bin doesn't if there's a 30 mm charger in it. If you'd rather have a plain floor, use the flat_floor file.
It's a long print: about 10.5 h for the housing and 9 h for the drawer, around 220 g of PETG total. No supports.
No load rating and I haven't printed it yet, so keep it light and test the stop with the drawer empty. Screws only, adhesive mounting won't hold this.
This model is licensed under
Creative Commons Public Domain
This licence allows derivative works. Open it in a tool to build on it — credit is filled in for you when you publish.
Discussed in
Similar models
test print • tolerance test • skadis
Fit Test Kit for SKADIS Hooks, Gridfinity Bins and Drawer Rails
gridfinity • microsd • sd card holder
Comments