Description
Small pieces that check each fit used in my organizer stuff, so you find problems on a 5 minute print instead of a 7 hour one. A few hours for the whole set, around 49 g.
What each one checks:
- Socket coupon, two hook keys and a lock pin. Hang this on your actual SKADIS board. If the keys are tight in the slots or loose in the socket, you'll know before printing a whole rack.
- Slot gauge. Only tells you the keys printed to size. It doesn't replace trying them on a real board.
- Gridfinity foot coupon. Should drop into your baseplate without pushing.
- Gridfinity cell coupon. Same pocket as the floor of the under desk drawer I'm working on. A normal 1x1 bin should sit flush in it.
- Clip rail coupon and one clip. The clip should slide on with light friction.
- Drawer rail housing and runner. The runner should slide along without binding or rocking more than about half a millimeter.
If the Gridfinity foot binds, look for elephant's foot on your first layers before you start scaling anything. Some SKADIS boards measure closer to 5.2 x 15.2 mm slots instead of 5 x 15, the keys have 0.3 mm of room per side at 5 mm.
These are for the cable rail, the screwdriver rack and the rest of what I'm posting. Fibreboard SKADIS only, I haven't looked at the metal boards. Use PETG for keys and pins.
I haven't printed these yet either, which is kind of why I'm posting them. Tell me what you get.
This model is licensed under
Creative Commons Public Domain
This licence allows derivative works. Open it in a tool to build on it — credit is filled in for you when you publish.
Fit Test Kit for SKADIS Hooks, Gridfinity Bins and Drawer Rails
Print Profiles
+Show Print ProfilesDiscussed in
Similar models
under desk drawer • gridfinity • hidden storage
Under Desk Drawer with Gridfinity Floor (fits 180mm beds)
caliper holder • digital caliper • skadis
Caliper Holder for SKADIS (150mm digital calipers)
Apple Watch • Apple Watch stand • Series 11
Comments