Description
Keeps a 150 mm digital caliper standing jaws down without anything touching the measuring faces. It rests on the outer edge of the fixed jaw in a shallow groove and leans back 6 degrees against a pad near the top of the beam. Gravity keeps the slider closed. The inside jaws and the end of the beam sit over a 2 mm gap so they don't touch either, and the side walls keep the jaw tips from getting knocked.
Fits
Calipers with a 16 mm beam and 40 mm outside jaws about 3.5 mm thick, roughly 233 mm long overall. That's the size of the usual Mitutoyo 150 mm digital one. Other brands are close but not identical, so check that the beam slides between the guide posts before you hang it.
Printing
87 x 176 mm, just fits a 180 mm bed. Back face down, no supports. There are a couple of small 2.5 to 3 mm overhangs at the jaw groove that most printers handle fine. Hook keys and the lock pin in PETG.
The keys are 40 mm apart and the pin goes in the slot 100 mm below them. If you haven't used these keys before, the fit test kit is quick.
Haven't printed it yet.
This model is licensed under
Creative Commons Public Domain
This licence allows derivative works. Open it in a tool to build on it — credit is filled in for you when you publish.
Discussed in
Similar models
test print • tolerance test • skadis
Comments