Description
Rail for SKADIS with clips you can move around. Each clip drops into one of the gaps in the rail and slides sideways onto a segment, so you can add clips, move them or change sizes without taking the rail off the board.
Clip sizes go by cable thickness:
- S for 3 to 4.5 mm (phone cables, most USB-C)
- M for 4.5 to 6.5 mm
- L for 6.5 to 9 mm (thicker power cords)
There's also a coil hook for a wound up cable or a light headset.
The channels are open on top and cables just sit in them. That's on purpose so you can lift one out with one hand, but it also means a thin cable in an L clip can hop out. Use the smallest clip that fits.
The 3MF has one of each clip plus the hook, so duplicate whatever sizes you need. Two S, two M and an L is probably a good start. The rail is 156 mm with 5 segments and the keys are 120 mm apart. For a narrow board there's a 3 segment version, about 97 mm.
It hangs on two printed hook keys plus an optional lock pin that stops it lifting off when you yank a cable. Print the keys flat on their side in PETG and push them into the sockets on the back. Then hold the rail about 7 mm above where it should end up, push the keys through the slots and let it drop. The little rail coupon and test clip are worth printing first, the clip should slide on with a bit of friction.
Everything prints without supports. Nothing has been printed or hung on a real board yet, so the fit is from CAD only.
This model is licensed under
Creative Commons Public Domain
This licence allows derivative works. Open it in a tool to build on it — credit is filled in for you when you publish.
Discussed in
Similar models
test print • tolerance test • skadis
Fit Test Kit for SKADIS Hooks, Gridfinity Bins and Drawer Rails
caliper holder • digital caliper • skadis
Comments