Description
Made this because my charging cable keeps sliding off the back of the desk. Modules screw under the front edge, and each one has three rail segments for clips.
The USB-C dock has a 5.4 mm channel. The cable fits through and the plug doesn't, so the end stays parked at the edge where you can reach it. The M and L clips are the same ones as on the SKADIS cable rail, so they swap between the two.
The 3MF has one of each part. For one desk I'd print 2 modules, 4 docks, 2 M clips and an L. Modules are 84 mm wide, and the long file is 114 mm with four segments.
Mount the rail face flush with the desk edge or up to 2 mm back. Two #8 countersunk wood screws per module, 12 to 16 mm long, into wood or particle board.
Print the modules on their side the way they're exported, so there's no layer line at the corner that takes the load. Clips go flat on their side. PETG, no supports.
One thing to check: the dock only stops plugs with a housing thicker than 5.4 mm, and some slim ones aren't. Still CAD only for now.
This model is licensed under
Creative Commons Public Domain
This licence allows derivative works. Open it in a tool to build on it — credit is filled in for you when you publish.
Discussed in
Similar models
cable organizer • SD card holder
Snap-In 5-Channel Cable Organizer & USB/SD Card Dock — No Supports, One Piece
Moto G • Motorola • cable organizer
Comments