Description
A single-piece landing place for the things that scatter across a small desk: a phone, loose items and charging leads. The low front tray keeps small objects accessible, while a rear phone channel and three open cable guides give each item a place.
The phone rest uses two front stops separated by a finger-access opening. The cable guides are open at the top, so cables can be laid in without feeding connectors through holes. They guide cables; they are not locking clamps. A connector wider than its groove may help prevent a lead slipping backwards, but retention depends on the actual cable and needs testing.
DIMENSIONS AND FIT
- Overall: 160 x 110 x 34 mm; STL units: millimetres.
- Flat floor: 3 mm; outer rim: up to 8 mm high.
- Phone channel: 21 mm clear front-to-back at floor level, between the sloped front stops and back rest; approximately 100 mm between the end ramps.
- Intended first fit test: a phone in a case no more than 12 mm thick and 85 mm wide in portrait orientation. These are design targets, not verified compatibility claims. The resting angle depends on device thickness and placement.
- Landscape placement may allow side access to a charging socket. Upright bottom-port charging is not a supported claim: this design has no through-base charging hole.
- Three cable grooves: nominal 4, 5 and 6 mm width, measured at their narrow lower portion. Use a groove larger than the cable jacket; do not force a cable into it. Printed clearances depend on printer calibration.
- Small objects belong in the open front tray. Not designed as a tablet stand or for food contact.
PRINTING — SUGGESTED STARTING SETTINGS
Place the broad flat underside on the build plate. Suggested material: PLA for indoor desk use away from heat. Start with a 0.4 mm nozzle, 0.20 mm layer height, 3 walls, 4 top/bottom layers and 15% infill. The geometry has no enclosed bridges or downward-facing overhangs above the base and is designed to print without supports. Inspect the sliced preview before printing; settings have not been verified in a slicer. A brim may help if your printer tends to lift broad flat parts. No screws, glue or assembly required.
DEVELOPMENT STATUS
Digital prototype v1, not physically printed or tested. Mesh checks confirm a closed surface, consistent face winding and no zero-area triangles. These checks do not establish stability, device compatibility, cable retention or finished print quality. All supplied pictures are CAD renderings, not photos of a printed object. Before relying on this model, check the fit, stability and surface finish with your actual phone and cables. If the base slides on your desk, optional non-slip pads may be needed.
AI DISCLOSURE
The concept, geometry-generating code, CAD renderings and draft documentation were developed by an AI assistant at the entrant's request. The participant has not claimed to have manually modelled or physically tested the object. No existing model or third-party brand artwork was used as an input.
This model is licensed under
Creative Commons Attribution-NonCommercial-NoDerivs
Desk Harbor — Phone Rest, Catch-All Tray & 3 Cable Guides Entered in Desk Organizers & Stands
Print Profiles
+Show Print ProfilesDiscussed in
Similar models
phone stand • desk organizer • desk tray
Case-Friendly Phone Stand & Desk Tray — Fits Phones in Cases up to 84 mm Wide, No Supports
DeskOrganizersChallenge • CallCove • desk organizer
CallCove — Phone Dock with Open Charging Access & Catch Tray
studybridge • bookstand • deskorganizer
StudyBridge — Raised Book Stand with A4 Notebook Space & Phone Dock
cable guide • cable management • desk
Comments