Description
Plain box with a lid that runs in dovetail grooves along both sides and the back. It can't lift off when it's closed, and the front wall is cut down so the lid slides out.
The grooves lean at about 30 degrees, which lets the box print upright without supports. You can add dividers in either direction, a thumb scoop at the front of the lid and a word engraved on top.
clearance is 0.25 mm by default. Go up if the lid sticks and down if it rattles. Outside sizes run from 3 cm up to 25 cm.
Category
License
This model is licensed under
Creative Commons Public Domain
Discussed in
Similar models
Customize “Small Box With a Sliding Dovetail Lid”
Adjust the parameters, then download your version. Everything renders in your browser.
Rendered locally with OpenSCAD — your settings never leave this page.
Comments