Description
ClearFlow — Removable Sponge Rack and Sloped Sink Tray
A two-piece organizer for a sponge or cleaning brush beside a sink. The open rack lifts out so both pieces can be cleaned; the tray floor descends approximately 5 mm from back to front towards a 32 mm opening. The tray is 150 x 100 x 20 mm; the removable rack is 137 x 86 x 3 mm. Place the opening over a suitable sink edge. Sink rims and counter geometry vary: fit and drainage must be checked on a physical print. Water can cling to the lip or run onto the counter; do not leave the setup unattended before testing.
Print both STLs flat as supplied, separately. Suggested starting point: PETG, 0.4 mm nozzle, 0.2 mm layers, three walls and 15–20% infill. Inspect the slicer preview and use supports where needed. Settings and support requirements are unverified. Assemble by placing the rack on the two side supports; no fasteners are needed. The rack is not clipped in and can lift or move.
Water contact: yes; not intended for direct food contact. Hand-clean regularly, remove the rack, wash both components, and allow them to dry. FDM layer lines can retain residue. Dishwasher safety and thermal resistance have not been tested; do not claim either. Avoid prolonged hot-water exposure and follow the filament manufacturer's guidance.
Status: digital prototype. Both STL files were checked as closed, consistently wound single solids; the CAD assembly showed no volume overlap. No real print, drainage test, slicer test, strength test or cleaning test has been performed. Images are CAD renders, not photographs.
AI disclosure: the concept, geometry code, renderings and documentation were developed by an AI assistant at the entrant's request. Research on cleaning and standing water informed the design. No third-party model was copied.
This model is licensed under
Creative Commons Attribution-NonCommercial-NoDerivs
ClearFlow — Removable Sponge Rack and Sloped Sink Tray Entered in Home & Kitchen
Print Profiles
+Show Print ProfilesDiscussed in
Similar models
HomeKitchenChallenge • sponge holder • sink organiser
FlowDock — Open Sponge Rest & Draining Tray, 124 × 99 mm
sponge holder • sink organizer • no supports
Self-Draining Sponge & Brush Caddy — Two-Bay Sink Organizer, No Supports
HomeKitchenChallenge • drying rack • draining tray
Comments