Description
What it is
A sink-side caddy for sponges, steel wool and dish brushes that never stands in its own dirty water. Both bays drain down a 9.2 degree ramp: drips run along the ridge channels and off the front lip into the sink, so nothing pools and nothing smells. Two bays keep the greasy sponge apart from the clean scrubbers, a 12 mm comb at the front holds the sponge in, and the whole part prints flat with no supports.
Dimensions (mm)
160 W x 95 D x 70 H. Sponge bay 90 x 91 inner, brush bay 58 x 91 inner, 4 mm walls and divider. Rim 28 front to 70 back (23.9 deg). Drainage ramp 2.6 to 17.0 (9.2 deg), ribs 2.5 tall, comb 12 tall. Bed contact 160 x 95 = 15,200 mm2. Fits a 180 x 180 mm bed.
Print settings
PETG recommended, PLA works. 0.4 mm nozzle, 0.2 mm layers, 3 perimeters, 4 top and bottom shells, 20 percent gyroid infill, no supports, no brim, print as oriented with the base on the bed. About 110 g, 4 to 5 h.
Check
The exported STL was re-parsed and tested independently: closed 2-manifold, single shell, Euler characteristic 2, outward normals, +221.65 cm3, 0 degenerate triangles, min Z 0.000 over the whole footprint, 0 surfaces needing support, steepest face 23.9 deg.
AI-assisted CAD
The solid was generated parametrically by a Python/numpy script from the dimension table and validated on the exported mesh. Original design, no remix, no trademarks.
File
kitchen-caddy.zip holds kitchen-caddy.stl (binary STL, mm).
This model is licensed under
Creative Commons Attribution-NonCommercial-ShareAlike
Self-Draining Sponge & Brush Caddy — Two-Bay Sink Organizer, No Supports Entered in Home & Kitchen
Print Profiles
+Show Print ProfilesDiscussed in
Similar models
sponge holder • sink caddy • kitchen organizer
Two-Bay Sponge and Brush Caddy with Drain Slots
sponge holder • sink organizer • drain tray
ClearFlow — Removable Sponge Rack and Sloped Sink Tray
HomeKitchenChallenge • sponge holder • sink organiser
Comments