Description
This test I’ve created allows you to calibrate the flow rate for both the first and last layers in one single print.
After the first layer, the print will pause so you can note which flow setting works best for that layer.
Once the print is finished, you can note the best flow setting for the last layer.
You can then apply these first and last layer flow settings in your slicer.
Category
License
This model is licensed under
Creative Commons Attribution-NonCommercial-NoDerivs
Similar models
18110
3dprinter • calibration • test
Inital layer flow ratio calibration- Quick and Simple
17550
calibration • top layer • 3d printed top layer
Top Layer flow rate calibration - Get smooth top layers with no lines
24260
7686
1092
425
Comments