Description
I wanted an easy way to tell charged packs from flat ones in the bag. Cap on means charged. When you use the pack, turn the cap around and push the two pegs into the contact holes. Now it sticks out the end and you can feel it even in the dark.
- Capped: the housing goes 11 mm into the cap and a small bead at the mouth holds it (0.2 mm per side).
- Parked: the pegs plug into the female contacts, so they stay covered either way.
There's an eyelet on the side if you want to leash it with a zip tie or some cord.
Print in TPU 95A, mouth down, no supports. The inside roof is a 45 degree tent so it doesn't need any. I'd use 4 walls, 100% infill and slow outer walls (25 to 30 mm/s). Each one is about 2 g. Dry your TPU first, stringing between the pegs is the main thing to watch for. Printing two at once helps the pegs cool.
Print the fit ring first and push it on. It should take a firm push and not fall off when you shake it. If it's off, the bead (try 0.1 mm steps) and the peg fit (0.2 to 0.3) are the numbers to change.
Versions:
- XT60 with pegs
- XT60 plain, no pegs
- XT30, no pegs. I assumed a 5.2 mm thick housing for this one, so check the fit ring
Not for XT90, EC5, Deans or MR30/MR60. It's a dust cap, not a seal and not fire protection. Take it off before you plug in.
Not printed on my end yet, treat the first couple as a test.
This model is licensed under
Creative Commons Public Domain
This licence allows derivative works. Open it in a tool to build on it — credit is filled in for you when you publish.
Discussed in
Similar models
AirTag • AirTag 2 • AirTag holder
Comments