Description
Balancing on fingertips works until it doesn't. This stand puts two soft TPU ridges under the wing at your CG mark, so a nose or tail heavy plane tips one way and you can actually see it.
The uprights print lying down so the layers run along the posts. They slide on two rails with 10 mm marks from the center line, and each one locks with an M5 screw and a nut that sits captive in the foot.
Setup:
- Drop an M5 nut into the slot in each foot.
- Put the uprights on the rails and start the screws from the end of the foot.
- Set both to the same mark on each side and tighten.
- Mark the CG under the wing and set the plane on the pads.
Hardware is just 2x M5 x 16 (socket head or thumb screws) and 2x M5 nuts.
Standard takes fuselages up to about 150 mm wide and prints on a 180 mm bed. Tall goes to 190 mm but needs a 250 mm bed. Mini is for 125 mm.
Uprights are PETG, 4 walls, 25% infill, rails at 100%. Pads in TPU 95A, solid. All flat, no supports.
It's not a scale and I'm not claiming any load rating, it's meant for light foam and balsa planes you can lift by the wing roots. Not printed yet.
If you need somewhere to park the fuselage afterwards, I posted a cradle too.
This model is licensed under
Creative Commons Public Domain
This licence allows derivative works. Open it in a tool to build on it — credit is filled in for you when you publish.
Discussed in
Similar models
HomeKitchenChallenge • sponge holder • sink organiser
Comments