Description
Bench cradle for working on a fuselage. Two V end plates and two spacers that slot together with half lap joints, no glue and no screws. Four TPU pads clip over the V edges so the plane sits on something soft instead of a 4 mm plate edge.
It comes apart flat, about 25 mm thick stacked, so it fits in the field box.
Sizes:
- standard, fuselages about 40 to 100 mm wide (fits a 180 mm bed)
- small, 25 to 70 mm
- wide, up to 150 mm (needs a 220 mm bed)
Plates and spacers in PETG or PLA, 30% infill. Pads in TPU 95A at 100%, channel up. Nothing needs supports.
No load rating. It's for holding the plane while you work on it. Don't run the motor with it sitting in there, and it isn't meant for transport.
Haven't printed it yet. If the slots come out tight, sand them a bit rather than forcing them.
This model is licensed under
Creative Commons Public Domain
This licence allows derivative works. Open it in a tool to build on it — credit is filled in for you when you publish.
Discussed in
Similar models
FunctionalPrintsChallenge • v cradle • dowel rest
Comments