Description
Holding a ruler behind the elevator never gives me the same number twice, so I drew this. It clamps onto the stab (or wing, or fin) and you read the travel right off the scale at the trailing edge.
Three flat parts and no hardware. The arm slides down the frame and clicks onto a row of ratchet teeth when the jaws close on the surface. Pinch the collar to let it go. The scale rider slides too, so you can put zero at neutral and skip the math.
- Clamp it on the fixed surface with the scale just behind the trailing edge.
- Center the surface (the neutral lock works for this) and slide the rider so 0 lines up.
- Move the stick and read the travel in mm.
The scale reads to 1 mm from two staggered rows of ticks at 2 mm pitch, numbered every 10 mm both ways. Rub some paint or crayon into the ticks so they're easy to read.
The standard size takes surfaces 0 to 30 mm thick with control chords up to about 85 mm. Compact and large versions are in the files too.
PETG at 0.2 mm, frame and arm with 4 walls and 30% infill, the scale at 100%. Everything lies flat, no supports.
Things to know:
- reads mm, not degrees
- clamp force isn't limited, so go easy on soft foam or put felt under the jaws
- remove it before flying
Not printed yet. Let me know if the ratchet ends up too stiff or too loose.
This model is licensed under
Creative Commons Public Domain
This licence allows derivative works. Open it in a tool to build on it — credit is filled in for you when you publish.
Discussed in
Similar models
desk clamp • headphone holder • c-clamp
Comments