Description
Two small tools for hinging control surfaces.
Marker: the usual two post center finder. Set it on the edge of the stock and twist until both posts touch. The hole is now on the center line no matter how thick the stock is. Put a 2 mm lead holder or a scriber in the hole and slide it along. To check it, run a line, flip the tool end for end and run it again. You should only see one line.
Sanding block: stick 120 to 240 grit paper on the angled face with double sided tape, lay the sheet flat and slide the block along the bench against the edge. The angle comes from the block instead of your wrist. It's hollow, so it's light and quick to print.
Standard has 30 and 45 degree faces and works on stock up to about 36 mm. The pencil version has an 8.2 mm hole for a regular pencil, 25 and 40 degree faces, and goes up to 47 mm.
PETG or PLA with 3 walls. Marker at 100% infill with the bar on the bed. Block at 20%, standing on its end. Neither needs supports.
The posts on the marker are small and could snap if it hits the floor. I haven't printed these yet either.
This model is licensed under
Creative Commons Public Domain
This licence allows derivative works. Open it in a tool to build on it — credit is filled in for you when you publish.
Discussed in
Similar models
FunctionalPrintsChallenge • sanding form • hand sanding
Comments