Description
A small angled pod that holds a standard 16 mm metal momentary push button on a dashboard or center console. It is meant for aftermarket train horn / air horn kits where the button does not carry the horn current itself but switches a 12 V relay (or an air-valve solenoid through a relay).
Design
- Button hole 16.2 mm through, with a 0.5 mm lead-in chamfer
- Button face tilted 15° toward the driver
- 3.0 mm top plate for the button nut to clamp on (most 16 mm buttons accept 1-6 mm panels); the bore is open at the bottom so you can thread the nut on from below
- 3.0 mm walls
- Rear cable slot (about 10.6 mm wide, pointed roof, no bridging)
- Flat 3 mm flange, about 10.5 cm² of contact for 3M VHB tape; 0.8 mm chamfer on the base edge against elephant's foot
- Overall size 52 × 48 × 39 mm
Why a relay
Horn compressors and solenoid valves draw far more current than a small panel button is rated for. Wire the button to the coil side of a 12 V automotive relay (terminals 85/86); the horn or compressor current goes through the relay's 30/87 contacts with an inline fuse near the battery. That keeps the heavy current in short, fused wires under the hood, and the button only switches the coil current (well under 1 A).
Print settings
- Material: PETG or ASA. A parked car interior gets hotter than PLA's softening point, so PLA will sag on a sunny dash.
- Orientation: as exported, base down. No supports. The only shallow overhang is the 4.9 mm nut-seat ring under the top plate; it is anchored on its outer edge and hidden by the nut.
- 0.2 mm layers, 4 walls, 4 top / 4 bottom layers, 25-40 % infill. No brim needed.
Install
- Push the button through the hole from the top, thread the nut on from below through the open bore, tighten.
- Solder or crimp the two wires and route them out of the rear slot.
- Clean the dash with isopropyl alcohol, apply VHB tape to the flange, press for 30 s.
Install and relay-wiring guides for horn kits: train-horn.com install guides. Check your local laws on where and when aftermarket horns may be used.
Files
horn_button_pod_16mm.stl (binary STL, mm, ready to slice) and horn_button_pod_16mm_source.zip: the parametric Python generator (Python 3 + numpy; all dimensions are parameters at the top), a validation script that checks the STL (watertight, consistent normals, hole diameter, wall thickness, tilt, flat base, overhangs) and the render script. The model was generated with this parametric Python script.
License: CC BY 4.0. Credit: Train Horn.
Images: computer renders of the STL and a section drawing (no photo of a printed part yet).
This model is licensed under
Creative Commons Attribution
This licence allows derivative works. Open it in a tool to build on it — credit is filled in for you when you publish.
Discussed in
Similar models
desk clamp • headphone holder • c-clamp
Desk C-Clamp Hook for Headphones, Bags & Cables (12-45 mm Desks)
AirTag • AirTag 2 • bike
Stash Hidden AirTag Bike Mount | Fits Under Standard Bottle Cages | AirTag 1st & 2nd Gen
cable grommet • tv mount • drywall
Comments