Description
Slate holds a closed MacBook upright next to your monitor. The base is low and shaped like a gentle wave, and it's open at both ends, so the ports on either side stay free and any length of MacBook slides right through.
Instead of a different stand for every laptop, there's one base and a soft TPU liner for each model. The liner grips the laptop snugly and keeps the aluminum off hard plastic.
Fits (one liner each)
- MacBook Air 13 and 15 inch, M2 to M5 (both use the Air liner)
- MacBook Neo
- MacBook Pro 14 inch (M5 family)
- MacBook Pro 16 inch
Bare laptops only. If you use a hard shell case, the source files let you make a liner for your exact thickness.
Printing
- Base: PETG, since laptops run warm when closed. Upright with the slot facing up. About 11.5 hours and 157 g.
- Liner: TPU 95A, upright with the U opening facing up. About 5.5 hours and 40 g.
- 0.2 mm layers, 3 walls, 20% gyroid for the base and 25% for the liner. No supports.
Setup
- Print the liner for your MacBook.
- Press it into the slot, chamfered edges up.
- Lower the MacBook in front edge first, ports facing left and right. On a MacBook Pro this keeps the hinge vents in open air.
Want to check the grip before committing to the full base? Print the two fit-test slices (about 10 g). The source files let you loosen or tighten the liner if needed.
Files
03_slate_macbook_dock_all_parts.3mf: every printed part, ready to sliceslate_base.stl,slate_liner_air.stl,slate_liner_neo.stl,slate_liner_pro14.stl,slate_liner_pro16.stl: the same parts as separate STLsslate_fit_liner_air_section.stl,slate_fit_slot_section.stl: optional fit testsslate_parametric_source.zip: CadQuery source and STEP files if you want to tweak anything
Part of Contour, my collection of quiet accessories for Apple gear.
Not made by or affiliated with Apple. Product names are only here to say what it fits.
This model is licensed under
Creative Commons Attribution-NonCommercial
This licence allows derivative works. Open it in a tool to build on it — credit is filled in for you when you publish.
Slate Vertical MacBook Stand | MacBook Neo, Air 13/15, Pro 14/16 | Swappable TPU Liners
Print Profiles
+Show Print ProfilesDiscussed in
Similar models
laptop stand • MacBook stand • laptop riser
Wing Laptop Stand Fins | MacBook Neo, Air 13/15, Pro 14/16 | 17° Ergonomic Riser, No Supports
MacBook Air • MacBook stand • vertical laptop stand
Fin Vertical Stand for MacBook Air 13 M4 & M5 | Lined Slot Laptop Cradle | Open Source CadQuery
phone stand • desk organizer • desk tray
Case-Friendly Phone Stand & Desk Tray — Fits Phones in Cases up to 84 mm Wide, No Supports
FunctionalPrintsChallenge • sanding form • hand sanding
Comments