Description
Two small fins instead of a bulky laptop stand. Put one under each side of your MacBook and it tilts up 17 degrees, raising the back about 70 mm. A better typing angle, more air underneath, and they slip into a bag when you're done.
A small lip at the front catches the laptop's edge. Each fin prints on its side with no supports.
Fits
- MacBook Neo, MacBook Air 13 and 15 inch, MacBook Pro 14 and 16 inch
- Pretty much any laptop at least 210 mm deep and 230 mm wide, up to about 2.2 kg
- Bare laptops or thin shells
Printing
Print two. PETG or PLA, on its side with the profile flat. 0.2 mm layers, 4 walls, 25% gyroid. About 5 hours and 68 g each.
Setup
- Stick 10 mm bumpers into the two recesses on top and two on the bottom of each fin. They keep everything from sliding.
- Place the fins about 190 mm apart with the lips toward you.
- Set the laptop on top with its front edge against the lips.
Files
wing_fin.stl: the main printwing_parametric_source.zip: CadQuery source and STEP files if you want to tweak anything
Part of Contour, my collection of quiet accessories for Apple gear.
Not made by or affiliated with Apple. Product names are only here to say what it fits.
This model is licensed under
Creative Commons Attribution-NonCommercial
This licence allows derivative works. Open it in a tool to build on it — credit is filled in for you when you publish.
Wing Laptop Stand Fins | MacBook Neo, Air 13/15, Pro 14/16 | 17° Ergonomic Riser, No Supports
Print Profiles
+Show Print ProfilesDiscussed in
Similar models
MacBook Air • MacBook stand • vertical laptop stand
Fin Vertical Stand for MacBook Air 13 M4 & M5 | Lined Slot Laptop Cradle | Open Source CadQuery
MacBook stand • vertical laptop stand • MacBook Air
Slate Vertical MacBook Stand | MacBook Neo, Air 13/15, Pro 14/16 | Swappable TPU Liners
iPad stand • iPad A16 • iPad Air
Easel iPad Stand with Apple Pencil Holder | iPad, Air, Pro & mini | USB-C Pass-Through
Mac mini • Mac mini M4 • Mac mini M6
Comments