Description
SnapPress is a compact prototype screw press intended for light assembly tasks with small parts. A removable coarse-pitch spindle advances a loose pressure pad inside an open-throat frame. Use gentle hand pressure with the work centred.
Prototype status
This model has not been physically printed or tested. Digital mesh and stationary assembly checks passed. Thread engagement, full travel, frame strength, pad alignment and printing orientation remain unverified. There is no established load rating. It is not intended for high-force work, heat, metalworking or safety-critical repairs. Images are illustrative product renders and CAD views, not photographs of physical prints. Use the supplied CAD files for exact geometry.
Files and dimensions
The ZIP contains three component STLs, an assembly STEP, digital validation notes and a print-test checklist. Units: millimetres. Frame: 70 x 98 x 42 mm. Open throat: 56 mm. Nominal spindle root diameter: 10.7 mm; thread major diameter: about 12.7 mm; pitch: 3.2 mm. Pad: 16 x 8 x 16 mm.
Suggested starting settings
Start with PLA for fit checks. 0.4 mm nozzle, 0.20 mm layers, 4 walls and 30% infill. Lay the frame on its broad side. Consider printing the spindle with its axis vertical and knob on the bed. Print the pad with its flat pressure face down and socket upwards. Inspect the full thread, bore and overhangs in the slicer; supports may be needed. Parts are in assembly coordinates and must be oriented and placed separately on the bed. Settings are untested.
Assembly and use
Start the spindle into the frame from the knob side. Place the loose pad against the smooth spindle tip, socket towards the tip. Confirm free travel without a workpiece before applying any light pressure. If the thread binds, stop and revise the fit rather than forcing it. Check the pad stays aligned. No strength claim follows from a successful light test.
AI assistance: concept development, CAD, digital checks and listing text were prepared with AI assistance. No physical testing is claimed.
This model is licensed under
Creative Commons Attribution-NonCommercial-NoDerivs
Discussed in
Similar models
gridfinity • tweezers holder • precision screwdriver
gridfinity tray for tweezers and precision screwdrivers
MagSafe • MagSafe charger • cable organizer
Spool MagSafe Charger Travel Reel for A2140 | Cable Winder with Puck Pocket | Open Source CadQuery
sponge holder • sink organizer • drain tray
ClearFlow — Removable Sponge Rack and Sloped Sink Tray
desk clamp • headphone holder • c-clamp
Desk C-Clamp Hook for Headphones, Bags & Cables (12-45 mm Desks)
Galaxy Z Fold6 • foldable • Samsung
Comments