Description
Arc turns Apple's own MagSafe Charger into a small sculpture for your desk or nightstand. The charger presses into the round head, the cable tucks away down the back, and your iPhone just floats there. Turn the phone sideways for StandBy.
No glue needed. Six small ribs inside the head grip the charger, and there's a notch so you can pop it back out later.
Fits
- iPhone 12 through 17, any model with MagSafe (mini, Plus, Pro and Pro Max included)
- iPhone Air and iPhone 18 Pro / Pro Max
- MagSafe cases are fine
- Not for iPhone 16e or other iPhones without MagSafe
You'll need
- Apple MagSafe Charger, 2024 or 2025 model, 1 m or 2 m (there's also a version for the original 2020 charger in the files)
- A 30 W or higher USB-C adapter if you want full 25 W charging
- Four 10 mm bumper pads (optional)
Printing
PETG is the better choice since the charger gets warm. PLA is ok if you charge at 15 W. 0.2 mm layers, 3 walls, 40% gyroid. The extra infill adds weight and helps it stay planted. Print it upright on its base, no supports. Roughly 8 hours and 98 g.
Setup
- Print one of the small fit rings first if you want to check the grip. The source files let you loosen or tighten it if needed.
- Slip the cable through the slot at the bottom of the head and the slit in the neck so it comes out the back. You never have to thread the plug through anything.
- Press the charger in, logo facing out.
- Clip the cable into the channel down the back and along the base.
One tip: slide or twist your phone off instead of pulling it straight back, or hold the base while you do. MagSafe is strong and the stand is light.
Files
arc_stand.stl: the main printarc_fit_ring_m010.stl,arc_fit_ring_p010.stl,arc_fit_ring_p025.stl: optional fit testsarc_stand_legacy_magsafe_A2140.stl: variant for the original 2020 MagSafe Charger (A2140)arc_parametric_source.zip: CadQuery source and STEP files if you want to tweak anything
Part of Contour, my collection of quiet accessories for Apple gear.
Not made by or affiliated with Apple. Product names are only here to say what it fits.
This model is licensed under
Creative Commons Attribution-NonCommercial
This licence allows derivative works. Open it in a tool to build on it — credit is filled in for you when you publish.
Arc MagSafe Charging Stand for iPhone 12-18 | Holds Apple 25W MagSafe Charger | StandBy Mode
Print Profiles
+Show Print ProfilesDiscussed in
Similar models
MagSafe • travel • cable organizer
Orbit MagSafe Charger Travel Spool | Cable Winder & Puck Holder for Apple MagSafe Charger
phone stand • iPhone stand • iPhone 16e
Cradle iPhone Stand with USB-C Pass-Through | iPhone 15-18, 16e, 17e & Air | Thick Cases OK
MagSafe • MagSafe charger • cable organizer
Spool MagSafe Charger Travel Reel for A2140 | Cable Winder with Puck Pocket | Open Source CadQuery
Apple Watch • Apple Watch stand • Series 11
Comments