Description
Prototype. I have not printed this or flown it. Please read the notes at the bottom before you put it in anything you care about.
The idea is to glue this frame into the foam instead of gluing the servo. The servo drops in from outside, the ears sit on the flange, and its own two screws go into the frame. When a servo strips, you take two screws out instead of digging it out of the wing.
- 5 mm flange that glues to the skin
- 6 mm collar that sits in the cut-out and gives the screws 8 mm of plastic
- 0.25 mm clearance around the case
- the hole in the wing is about 35.5 x 16 mm
I couldn't find a number I trust for the ear hole spacing on these servos, so the screw holes are slots that cover 26.8 to 30.8 mm. Print the 1.2 mm fit plate first and check that your servo drops through and both ear holes land on the slots. Two versions: sg90 for a 23.0 x 12.2 mm case and sg90_snug for 22.2 x 11.8 mm.
PETG or ASA, 3 walls, 100% infill, flange down, no supports. Comes out around 3.7 g. Not PLA, it goes soft in a hot car.
Notes:
- a loose servo in the air means no control of that surface. Check the screws and the glue joint before every flight until you trust it
- it adds a few grams out on the wing, so check your CG after
- not flight tested and not even test printed. If you try it I'd like to hear how it went
This model is licensed under
Creative Commons Public Domain
This licence allows derivative works. Open it in a tool to build on it — credit is filled in for you when you publish.
Comments