All resources
Transcript & details below

3D printing calibrations you should run, part 3: pressure advance

3D printer calibrations you should run, part 3: print the pressure advance pattern from your slicer, find the sharpest corner, then enable pressure advance in your filament settings and enter that value.

Tutorials Beginner 0:24 122 views Nov 16, 2026

About this video

Calibration part 3: pressure advance

If the corners of your prints bulge, or lines come out thick at one end and thin at the other, pressure advance is usually the fix. Melted plastic in the nozzle takes a moment to build up pressure and a moment to let it go. Pressure advance pushes a little extra filament as the print head speeds up and eases off before it slows down, so the line stays the same width through corners. The right value depends on your filament and printer, which is why it's worth calibrating.

The slicer in the video is Creality Print, which is built on OrcaSlicer, so OrcaSlicer has the same test in its Calibration menu.

How to run it

  1. Open the Calibration menu in your slicer and choose Pressure advance.
  2. Pick the PA Pattern method and click OK. The slicer generates rows of nested corners, each printed with a different pressure advance value and labeled with it. PA Tower and PA Line in the same dialog are other ways to run the test.
  3. Print it and find the line with the best result: a sharp corner and an even line width on both sides of it.
  4. Open your filament settings, tick Enable pressure advance and type that value into Pressure advance. In the video, the best line is 0.05.
  5. Save the filament profile.

What to look for

Pressure advance too low Pressure advance too high
Corners bulge outward Corners look thin or have small gaps
Blobs where a line ends Line ends fade out or leave gaps
Thin lines where a line starts Extra material where a line starts

Tips

  • Run it after temperature (part 1) and flow rate (part 2), since both change how the filament flows.
  • Read the pattern in good light and look closely at the tip of each corner.
  • If two lines look equally good, pick the value between them.
  • Run it for each filament, and again if you change the nozzle size.
  • Direct drive printers usually end up below 0.1. Bowden printers, with a long tube between the extruder and the nozzle, need higher values.
  • Not sure where the calibration menu is? Day 7 of learn 3D printing in 7 days shows it.

Pressure advance, linear advance and K factor

They're the same idea with different names. Klipper and OrcaSlicer call it pressure advance, Marlin firmware calls it linear advance and sets it with a K factor, and Bambu Lab printers measure the same value as K in their flow dynamics calibration.

What's next

Next up is part 4. Catch up on part 1: temperature and part 2: flow rate.

FAQ

What does pressure advance do?
It adjusts the extruder as the print head speeds up and slows down, so the line stays the same width through corners and at the start and end of each line.

How do I know my pressure advance is wrong?
Corners that bulge outward or blobs where lines end usually mean it's too low. Thin or gappy corners usually mean it's too high.

Do I need to calibrate pressure advance for every filament?
Yes. The right value changes with the filament, so save it in each filament profile.

Is pressure advance the same as linear advance?
Yes, it's the same idea. Marlin calls it linear advance, and Bambu Lab calls it the K value.

Full Transcript

3D printing calibrations you should run. Part 3. If your prints look terrible, open your slicer and click on calibration, then pressure advance, select the pattern and click OK. Print it and find the line with the best result. Then go into your filament settings and enable pressure advance so you can type your number. It's this easy, and part 4 is next.